I know this is a really dumb question but I really just have not other Idea what could be going on here.
I have tested the parameters in the tank 160 reef 30 - 40 gallon sump. the tank has been running for 10 months now reading over the last three weeks
sg 1.027 read with both hydrometer and refractometer
am 0, nitrite 0 nitrate 10 ppm
cal 385 - 400
alk 9.6 - 10.5
mg 1350
phosphate 0.00 - 0.05
tank temp between 76.7 and 77.9
Ok today I picked up a couple things that I have been neglecting to test in my system. I have never test phosphate until today I am going to begin testing with an ELOS expert line PO4 test kit and I am going to use reef results phosblaster super nuker liquid phosphate remover to remove the phosphate in my system.
the claim of this product is 1 point per treatment, the treatment is 10 ml per 50 gallons. I am going to be dosing 40 ML to treat 180 gallon system. the pictures taken
Hi I'm New here sort of. I have used many of the great articles posted on Melevesreef.com for a few years now, and The DIY section for building Sumps.
So here is a little back ground. I began keeping salt water aquariums around 1995. so for the last fifteen years I have had several FOWLR tanks and Three reef tanks two with moderate success.
My Current tank is a 150 gallon reef tank that has been mostly DIY. The tank is glass 72x18x28 I drilled the end of the tank and installed