View RSS Feed

Tumbleweed

Vortech Pumps

Rate this Entry
3 Comments
by
Tumbleweed
, 04-06-2010 at 10:42 AM (6245 Views)
Picked up a used MP40W last week from another member and then last night got a new EcoSmart MP40 and I have been playing with them ever since. Because I only have 1 EcoSmart pump I can not use any of the EcoSmart programs with both pumps so I have it setup currently in long pulse mode at about 80-85% power and 10sec pulse. I also have it go into night mode at about 10pm when all of my lights turn off. So I was just wondering what program everyone else is using and why?

Submit "Vortech Pumps" to Digg Submit "Vortech Pumps" to del.icio.us Submit "Vortech Pumps" to StumbleUpon Submit "Vortech Pumps" to Google

Categories
‎ Plumbing

Comments

  1. agsansoo's Avatar
    I use Reef Crest (high energy reef environment) mode 100% of the time. Then when my lights go out it switches into night mode. This just works for me. That's why I purchased a mp10 (old style) this month. Couldn't justify the extra cost for the EcoSmart driver if I only use Reef Crest mode !
  2. melev's Avatar
    Mine are set to Reefcrest all the time, and I have an MP20 on the back of my tank in a slower pulse mode. This pushes water through the corals on the right-middle section of my tank, keeping the BTA toward the front of the tank. That pump draws in fresh water and pushes it forward, which helped decrease what I felt was a low-flow area.

    I'm getting the Eco-Smart drivers too, so I may decide to change it up a bit.
  3. Aquarius Marinus's Avatar
    I think that the ES mode is the coolest thing ever. When I build my 180 next month I am ordering 2 MP40W ESs and maybe if I can an MP10W ES for the back and run them on the "Tidal Swell Mode".
    But....I obviously don't have them yet...so no real experience here, just excitement!