42 Gallon Hex build
by
, 08-04-2015 at 08:21 PM (939 Views)
The first 2 photos are of the diverter used to channel any water spilled at the back of the tank to the stand. The third photo is of the diverter in place without the trim around the top. this view is from the top of the cabinet. The forth photo is from the top with the trim glued in place. The top outer frame assembly also has trim in place to channel the spilled water into this diverter. The last photo is a view from the stand side of the back cabinet. Please excuse it being sideways. I tried rotating the photo but it still come up sideways when I upload the photo. The bulkhead for the conduit from the front electronics area is also mounted just under the diverter. At the top of the assembly is trim that overlaps the top trim on the stand. This is to prevent any water that has splashed down the side of the tank from getting between the side panels and the stand. The flap over the pass through has also been installed in this photo. This is to prevent splashed water from entering the back cabinet electronics area.