42 Gallon Hex build
by
, 07-08-2015 at 07:24 PM (620 Views)
The first photo below is the parts for the barrier between the sump area and the electronics area of the stand. The next photo is the barrier assembled. Next is a photo of the inner stand assembled and glued, bottom view. The next photo is a front view with the barrier imstalled. It has holes drilled and inserts installed to mount modules for the controller. Note the opening near the bottom is for the wires and cables for the sensors. The next photo is a view from the top of the inner stand. The last two photos are with the sump installed to check for fit. Notice the two round holes in the barrier in these photos. Those are openings for PVC pipe to allow cables and wire to travel from the front electronics area to the rear electornics area without exposure to the sump area. Next is painting the inner frame assembly.