View RSS Feed

melev

Another big sump gone

Rating: 2 votes, 5.00 average.
6 Comments
by
melev
, 07-07-2012 at 03:25 PM (3792 Views)
I ship a lot of sumps, but the ones that need to be crated seem to be more important, so I'm sharing.

This one is made with 3/8" cast acrylic, and is 48" x 24" x 16". It's a tough sump. This is the front of the sump. It will be installed in a basement with the refugium side up against a wall.



The three zoned sump provides both a skimmer section, a long refugium zone, and a large return section to hold all the reactors and gear. The skimmer stand is wrapped up for shipping in these pictures.



The bubble tower has a 1.5" bulkhead for one drain line. The skimmer section is 17" x 20", providing room for a protein skimmer with a 16" x 16" footprint. Included in the order was a 16" x 16" x 3" skimmer stand to put the skimmer at the desired 6.5" water depth. A piece of PVC will be installed by the customer into the bottom side of the bulkhead to direct the water cleanly into the sump.



The refugium is 6" wide, and runs full length to drain into the return zone. It will be lit with LEDs. The bulkhead is 1".



The external pump will connect to this 1.5" threaded/slip bulkhead. The threaded side is to screw in a strainer, and the slip side accepts PVC or SpaFlex tubing.





I rounded over the edges for this customer.



Packing time.











It weighed in at 200 lbs at Fedex. I really thought it was going to be 125 lbs.

Submit "Another big sump gone" to Digg Submit "Another big sump gone" to del.icio.us Submit "Another big sump gone" to StumbleUpon Submit "Another big sump gone" to Google

Categories
‎ melevsreef

Comments

  1. Midnight's Avatar
    You really need to get these freight guys to give you a break as you are doing more and more. That sump style seems to be over taking the model F nowadays :-)
  2. melev's Avatar
    Yeah, but it's harder to make! I want more F'ing customers.
  3. Midnight's Avatar
    Well fortunately most people have narrow tanks and can only fit f'ing sumps
  4. Eddie Howard's Avatar
    Question: The piece of PVC or flex that goes down to the bubble trap should be how long -- how far into the bubble trap?

    Thanks
  5. Midnight's Avatar
    To the water level, or just below, wherever seems to make less bubbles and noise
  6. melev's Avatar
    Correct. It's about 6.5" worth of PVC, with about 1" pressed up into the bulkhead and the base should be submerged 1/2". The rest of the area under the pipe should be filled with rock rubble.