rossbryant1956

attaching aquarium heaters to my sump

Rate this Entry

7 Comments

rossbryant1956

, 01-30-2011 at 10:15 PM (2727 Views)

I am getting closer to actually putting water in my first tank every day but seems I have to stop and ask you guys a question. Today I am wondering what ideas you have to make sure the aquarium heaters stay in place in the sump. The little stick-on suction cups do not work worth a flip. I thought about sticking some silicon in there but wanted to seek advice before I did.

As always, thanks for the advice.

Categories: ‎ Uncategorized

« Prev Main Next »

Comments

dread240 - 01-30-2011 10:39 PM
I just lay mine in there... and that's it... they go to the bottom
Sisterlimonpot - 01-30-2011 11:03 PM
although there is a "do not submerge past this line" mark, i do the same thing.
DJ in WV - 01-30-2011 11:07 PM
no you need a submergeble one to lay it on the bottom
Midnight - 01-31-2011 12:01 AM
if it will fit it the bubble trap and not stop flow that is a good spot
Heathd - 01-31-2011 01:20 PM
Fosters and smith sells magnetic holders for heaters if you are truly concerned about it holding to the wall. Just check to make sure that they are rated for the thickness of the acrlyic or glass used in your sump.
Alaska_Phil - 01-31-2011 07:04 PM
I use a fully submersible one and also just lay it on the bottom.
rossbryant1956 - 01-31-2011 08:06 PM
Thanks everyone. I am going with the advice of the group. My fear was laying it directly against the glass, either on the bottom or up against the side so I decided to use the suction cups but as a base rather than requiring themto actually work...which they don't.

New 55 gallon tank. Started making water tonite!!!