Recent Blogs Posts

I now have three fish. I went looking for a first fish and ran across some blue reef chromis damsels. I got three of them. These things seem to be hungry all the time. I guess that s a good thing though. They are active during the day and are always out above the rocks. All seem to be getting along OK. They always seem to be hungry. When I got home I tested the water salinity the new fish were in and got 37 mS. I rechecked it with a refractometer and got 24ppt. Is it normal for LFS's to keep their ...

I removed the sump from the system Sunday a week ago. I just got it installed back in the system Monday evening. While it was out I completed the drain line plumbing to the Sump. I made a acrylic cooling fan holder and also a probe holder that allows probes to be added in the bubble trap. I also made the feet for the corner boxes along with a acrylic cover for mounting float switches to the return compartment and probe holders to the refugium compartment. I was in a hurry so I did not get a lot ...

I mentioned the leak detect float switches in my last blog. So I figured I would post so information on them here. In the first photo is one bracket assembles and the parts for the second bracket. The second photo has the marks used to drill the hole for the float switch on the small part and the holes for the mounting screws on the long part. For this I used a combination square. I admusted it to near center to make the marks. This got me 2 parallel line. I just drilled the holes in the center ...

Attached Thumbnails

         

 

I ran a leak simulation this weekend. I actually ran my Drinking water RO output to the tank and let it run down the outside of the tank to simulate an overfill, splash down the side or a leak at the seam of the tank. I let it run until the leak detection float switch was tripped. I only had a little puddle on the bottom outer frame at one of the side doors and a trickle in the front electronics compartmant where the conduit enters. A single drop ran down the back panel of the compartment. I have ...

The first few photo's are of the stand during the build. You can see the 2 PVC conduits that will have the wiring that runs from the front to back of the stand. There are 2 sets of hangers that are mounted between the 2 conduits. The return manifold is mounted to the hanger between the 2 conduits. The return manifold was shortened by one output and raised and mounted above the hangers after these photos. This was to allow removal of the skimmer from the sump without going to a lot of trouble. The ...

Attached Thumbnails