Stand was delivered. 4x4 cm 3mm think steel (1.6x1.6 inch 1/8" steel bars) Was 2.5 inches taller than ordered so had to cut down a bit from the legs, hopefully that won't make it very hard to clean under it. Also wasn't impressed by the epoxy paint they did so had it resanded and repainted on site by 3 coats of epoxy. which took a few days to get done. ...
Updated 06-11-2011 at 12:07 AM by maroun.c
I've gradually been putting together the frag tank over the past month or so. It's finally online. I love its look, and how it is tied into the 400g reef. It's a cute little thing, 22" x 13" x 8" with a 1" Durso drain in a 5" x 5" corner overflow. The locline feeding into the frag tank is adorable, I've never seen such tiny locline before. It's got a 1/4" outlet. The tank holds just under 10g of water. It didn't take me long ...
Bobby finally had a little time to come over and I put him to work. I needed a number of things resolved or completed. Two outlets in my home were flakey with bad connections, so he swapped those out. The AquaController 3 had stopped communicating with all the x-10 modules in the sump area, and he had the tool to replace the phone jack connectors on the wiring to the kind that fit the sockets correctly. All four were replaced to get a good connection, and now the x-10s ...