The first photo is of the parts to the bottom outer frame. The second photo is the parts for the top outer frame. The third photo is the top side of the bottom outer frame assembled. The forth photo is of the bottom of the bottom outer frame assembled. The bottom outer frame is attached to the base of the inner frame with 12 pocket hole screws. There was a strip of 1x2 added in the back after the photo was taken to allow the electrical boxes to be screwed to the bottom frame inside the back cabinet. ...
The first photo is of one of the back cabinet door's parts. The door was too narrow to have a raised panel so it is a standard panel. There are two doors one on each side. The next three photos are of the parts for the back cabinet that is attached to the back panel. The back panel is the same as the side panels with the exception it has no air vent at the bottom. The fifth photo is the center partition inside the cabinet. This is where the power bars for the controller will be mounted. The partition ...