So this is the stand I built I wanted it open enough to pull the sump out from the front the other section will be for electrical and a drower at the to if there is enough room also might put one in on top of sump section
Updated 01-11-2011 at 08:54 PM by melev
Is this bracing if so what kind (sorry phone pics)
Updated 01-11-2011 at 08:52 PM by melev
I guess I was going to fast and measured wrong. The overflow is one inch wide and the return is also one inch wide. The water is being drained from the bottom of the tank with a bulkhead Thanks everyone.What return pump should I get?
Updated 01-11-2011 at 08:49 PM by melev
So I filled my 75gal acrylic up to make sure there were no leaks and there are none but it bulges out a lot IMO is this normal?
I Plan on putting in a mag drive 7 return pump with a head flow at 4ft approx 480 gph which equates to about cycling the tank water about 4 times per hour. I'll split the returns to 2 with a SCWD and place them just off of center. I also have 2 Rio 1700 Power heads the the ends of the tank. Do I need more water current in the tank??? If so, I was thinking about the Koralias, just not sure what size/flow rate and position. Are there any good ideas for which water pushers need ...