Midnight

Hope you are excited as I am.

After all the changes, delays, and head scratching the tank should be delivered tomorrow afternoon. I will try to take pictures of what I can. The home for the tank is not finished being prepped, as I was expecting more lead time on knowing the tank's arrival. That said I will have a busy week getting the wall opening and stand leveling properly prepared.

Does anyone know of a store that would carry composite shims? I guess I could buy a composite deck board and slice the pieces to the exact width I need, does anyone see a problem with this for shimming the stand?

Well until the next post I will be a busy bee.

Here are pictures of the tanks' delivery:











I did find one small defect while inspecting the tank after unpacking it. It is a small wafer thin chip that is near the joint of the overflow to the end wall of the tank. I do not think this will have any physical affect on the tank nor a viasual one. What do you guys think, I have sent the pictures to the manufacturer also. the second picture is the actual piece laying on the top.