Do It Yourself projects
Below are photo's of the side panel parts and assembled side panel. Since this a hex tank the angle just didn't look right so i decided to add a column or the appearence of one. the parts at the left and right of the photo accomplish this when the side panels meet. They are also cut to make room for a recessed insert. I relied heavily on a router table for this build. I am by no means an expert at woodwork. This is my first attempt at something this major. Also all rail surfaces have a slant down ...
Updated 06-30-2015 at 06:23 PM by n2585722
Photo's of the finished inner frame assembly are below. It just needs final painting. The pocket holes in the shape of a V are for mounting the side panels to the frame.
The parameters I have to meet is that no wire or plumbing can be seen hanging off the back or otherwise. The water level at top of tank cannot be seen and the side of the gravel or sand bed cannot be seen. This was set down by the other half. I had to get an OK for the wires and cables to the wall plates. This included 5 tubes from a wall plate to the tank. I am glad I got a signoff on that otherwise this would not be possible. So this design is to keep as much as possible hidden from view. Now ...
The inner frame is used to hold the lighting above the tank and provide a barrier between the tank area and the lighting itself. Below is photos of the parts of the inner frame.
After being out of the hobby a few years I decided to get back in after a visit to Melev's website. So i decided to setup a smaller tank I had. It just happened to be a Hex tank. I wanted to used LED lighting so I needed a canopy to install the lighting in. So here goes.
Go to Profile
Mark as Read