The parameters I have to meet is that no wire or plumbing can be seen hanging off the back or otherwise. The water level at top of tank cannot be seen and the side of the gravel or sand bed cannot be seen. This was set down by the other half. I had to get an OK for the wires and cables to the wall plates. This included 5 tubes from a wall plate to the tank. I am glad I got a signoff on that otherwise this would not be possible. So this design is to keep as much as possible hidden from view. Now ...
After being out of the hobby a few years I decided to get back in after a visit to Melev's website. So i decided to setup a smaller tank I had. It just happened to be a Hex tank. I wanted to used LED lighting so I needed a canopy to install the lighting in. So here goes.
Go to Profile
Mark as Read